help

[abdushibi 0]

I have a problem with Press Brake  machine and I need help
The error shown in the attached image appears

[lem_on 69]

Helb! 

I need somebody

(Helb) not just anybody

(Helb) you know I need someone, helb

So much younger than today …

[Tad 198]

10 часов назад, abdushibi сказал:

The error shown in the attached image appears

If you talk about the message ENC not connected, you have to perform the following procedures in sequence.

1. Execute ENC connect procedure.

2. If it does not help - replace all lithium batteries.

3.  If it does not help - reinstall ENC.

4.  If it does not help - repair the CNC module.

[abdushibi 0]

 

TAD Thanks for the reply. Can you help me to do these steps, knowing that DNC is 84 PS

Изменено 2 августа 2023 пользователем abdushibi

[lem_on 69]

38 минут назад, Tad сказал:

If you talk about the message ENC not connected, you have to perform the following procedures in sequence.

1. Execute ENC connect procedure.

2. If it does not help - replace all lithium batteries.

3.  If it does not help - reinstall ENC.

4.  If it does not help - repair the CNC module.

А нафига вы этим лесным тюленям отвечаете? Даже оформит вопрос не могут нормально. 

Хелб, не работает. Чо нажать.

[Tad 198]

21 минуту назад, abdushibi сказал:

DNC is 84 PS

Unfortunately, I don't have any experience with such an old machine. You can execute only 1st point if you manage to find it in the menu. About rest points you need to find a good expert to repair this controller.

[Anat2015 363]

13 часов назад, lem_on сказал:

Helb!

Это по древнеарамейски?

[lem_on 69]

9 минут назад, Anat2015 сказал:

Это по древнеарамейски?