840D mmc100.2 waiting for communicating partners

[Moez 0]

Hello,

I am Moez from Tunisia
I bought a second hand machine (Finnpower SG6 punching machine), the machine was dismantled and then reassembled, and in between the machine was stored about two years. The machine was in working condition before dismantling.

Now, upon power up the machine the screen goes black and says "MMC100.2 version 04.04.22 waiting for communicationpartners " and all LED's on Machine control panel (MCP) will flash.

The NCU is NCU 573.2 / 32MB 6FC5357-0BB33-0AE1

Attached a short video showing the screen when I turn on the machine.

https://youtu.be/R71KAeXGt9U

https://youtu.be/W4jFluomhEw

https://youtu.be/rocSytM4a6k

Please can you help me to make this machine works?

Thank you.

[andrey2147 172]

Камрад, пиши по русски.

[andrey2147 172]

Find archives.Download to CNC

[gudstartup 719]

19 часов назад, Moez сказал:

The machine was in working condition before dismantling.

If you have a backup for NC and PLC, then you need to clear NC and PLC

When you say "Clean", you mean NC & PLC Clear?

Like this...

1. Set S3 on the 840D NCU to position #1
2. Power on control.
3. When the control is fully powered up Press the “Reset” pushbutton on the 840D NCU
4. Wait for display on NCU to show #6
5. Set S3 to 0 and push the “Reset” pushbutton.
6. Wait for display on NCU to show #6
7. Turn S4 to Position #2 - PS LED is ON.
8. Turn S4 to Position #3 - PS LED is OFF.
9. When PS LED comes on turn S4 to Position #2 then immediately back to position #3.
10. PS LED should now be blinking.
11. Set S4 to position #0. – PR LED should go to a solid green after a few seconds.
** If it is not procedure was not done correctly. Repeat PLC steps #1 through 4.**
12. Set S4 to position #2
13. Press “Reset” pushbutton on 840D.

 

Then restore your archives!

[Moez 0]

Thanks you, I tried as indicating, it seems one is clean but the other is not, I have one green light and one red light ps is red.

Still no communication with the mmc100.2.

Still message waiting for communicating partners...

Please what shall I do.

Thank you.

[gudstartup 719]

18 часов назад, Moez сказал:

I have one green light and one red light ps is red.

Send photos of the CNC state after power-on and when the message "waiting communicationpartners" appears on the MMC 100.2 screen.
Examine the status of your LEDs especially the status of the PLC according to the instructions in the attached file.

NCU Info.ZIP